4 Tricks for Washer Maintenance and Cleaning

September 7, 2016
A clean washing machine is a happy washing machine that will keep washing your clothes for years to come. Read these 4 tips to perform good washer maintenance and cleaning.

All the appliances in your home need regular cleaning, even if they’re used for cleaning other things.  The washing machine is one of those appliances that gets used a lot. Neglect can prevent it from properly doing its job and cleaning your clothes. Read this article to learn how to perform maintenance and cleaning on your washer.

Due to it being exposed to moisture so frequently, it’s common for mold and detergent to buildup. While you might be able to ignore it at first, over time it turns into a true problem, causing unpleasant odors that cling to your clothing.

Routine disinfection and washer maintenance not only prevents these kinds of inconveniences, but they also help keep its components in working order.

Luckily, there are a few tricks that use all-natural ingredients that will help you thoroughly deep clean your washer. Below, we’ll share 4 of the best washer maintenance tips you can use to keep your wash machine running and washing perfectly.

1. General cleaning and washer maintenance

Washing dirty clothes in washing machine

The combination of hot water and apple cider vinegar is one of the best solutions for washer maintenance. It can eliminate bacteria and mold while removing difficult stains. It’s a good idea to use this treatment at least once a month to prevent mold and bad odors from appearing.

Ingredients

  • Hot water
  • ½ cup apple cider vinegar

Instructions

  • Fill the washer with hot water, add the apple cider vinegar and run it through a short cycle.
  • Once finished, open the washer lid and let it air out for an hour.

Read this article too:

Tips for Keeping Your House Non-Allergenic

2. Filter cleaning

The washer’s filter is located inside the drum. It’s perhaps the most complicated part to clean and requires some careful attention. Here, it’s not so much about which product to use as it is cleaning out the filter and removing anything that’s become trapped inside.

Directions

  • Unplug the washing machine, making sure it’s totally empty, and remove the filter cover.
  • Unscrew the top to remove it completely.
  • Remove any fibers, papers, dirt or any other foreign objects from the filter.
  • Now take a screwdriver and use it to turn the turbine to remove any debris stuck inside.
  • Reinstall the filter securely before use to keep water from leaking inside.

3. Cleaning the seals

Mold in washer seal

Mold and bad odors tend to originate from the rubber seal because that’s where moisture collects. Although you can dry this area after each wash, some moisture will almost always remain and cause problems sooner or later. In order to kill germs and mold, use can use the antiseptic powers of hydrogen peroxide and lemon.

Ingredients

  • 3 quarts water
  • ¼ cup lemon juice
  • 1 cup hydrogen peroxide

Instructions

  • Extract the juice from a fresh lemon and immediately mix it in a bucket with the water and hydrogen peroxide.
  • Carefully observe how the seal is situated to make reinstalling it easier.
  • When you see mold, spray it with the lemon disinfectant and wipe with a sponge.
  • Clean all the way around the seal to completely eliminate mold.
  • Before replacing the seal, spray the seal one more time with the solution and wipe clean with a dry cloth.

Check out this article too:

How to Use Lemon and Other Natural Cleaning Products

4. Cleaning the soap and fabric softener dispensers

Washer dispenser

The soap and fabric softener dispensers often accumulate a lot of residues, especially if you use powdered detergent.

Cleaning them is simple and necessary because the substances can stick to the sides of the dispenser and decompose, which in turn causes unpleasant odors.

Ingredients

  • 1 cup white vinegar
  • 1 quart hot water

Instructions

  • Dilute the vinegar in the hot water.
  • Dry the dispensers and soak them in the solution for 10 minutes.
  • Wipe clean and dry.
  • If your dispensers are non-removable, spray them and scrub with a sponge.

How often do you have to perform washer maintenance?

It’s important to understand that you need to repeat these washer maintenance tips at least every two months to be effective because dirt and mold can accumulate quickly. Also, each time you’re finished washing with the machine, leave the door open to let it air out.

Kyi, M. S., Holton, J., & Ridgway, G. L. (1995). Assessment of the efficacy of a low temperature hydrogen peroxide gas plasma sterilization system. Journal of Hospital Infection. https://doi.org/10.1016/0195-6701(95)90206-6